On our website (and in some stores), you can find unfinished wooden storage crates that are often handy for out-of-sight storage, like in a garage. But their unstained finish may not make them a great storage option for your living room. With a bit of stain and some cabinet pulls, however, we were able to customize a DIY wooden storage crate to give it a more finished look.
For this project, you’ll need the following supplies:
- Small wooden storage crate
- Wood stain
- Cabinet pulls
- Putty knife
- Several varying grits of sandpaper or sanding blocks
- Wood filler
- Shims, paint stirrers, or scrap wood
- Staining pads
- Drill
- Screwdriver
Start by removing the sticker residue from the wood using a residue cleaner, and then sand the area thoroughly.
Next, use a couple of small shims or scrap wood (I used cut pieces of paint stirrers) and gently tack them to the inside of the crate. Because you’ll be filling the hand hole with wood filler, you’ll want a flat, even surface on the inside of the hole to fill.
Next, fill the hole with wood filler. I wasn’t careful on this side about getting the filler onto the surrounding wood, and unfortunately this can leave you with unevenness when you start staining later. If you want, be a bit tidier with the wood filler!
Let the wood filler harden overnight, then begin sanding the side of the crate. I prefer to use a sanding block rather than a piece of sandpaper because of its hard, flat surface. The block ensures the flat crate front will be smooth. Go “through the grain,” starting with a low-grit sanding block and slowly moving up to a high-grit (fine) sanding block.
The side of your crate should look like this — smooth, with no bumps or unevenness.
Next, begin staining! I used Minwax Jacobean stain and applied it with a staining pad.
Wipe the stain onto the wood, then use a clean staining pad to wipe away any excess.
Because I was filling my crate with pillows and throw blankets, I did not stain the inside of the crate. If I had stained the inside and any stain residue remained, it would have ruined my pillows and blankets.
Once your stain is fully dry (I suggest waiting at least a full day), mark where you’ll need to screw in your cabinet pulls.
Drill holes where you’ve marked, being sure to drill all the way through the wood filler.
You may need to drill from both sides.
Next, begin screwing in the screws for the cabinet pulls with a screwdriver.
Finish screwing in the pulls, and you’re done!
DIY Décor is a series about small, affordable design and décor projects for home and garden.
